Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Introduction
- To assemble the throttle handle
- To assemble the handlebar
- To assemble the handlebar
- To assemble the cutting equipment
- To attach the trimmer guard or combination guard for trimmer head and plastic blades
- To attach a trimmer head or plastic blade
- To attach the guard extension
- To remove the guard extension
- To attach the grass blade and the grass blade guard/combination guard
- To install the saw blade
- To install the blade guard
- To adjust the harness
- Quick release function of the harness
- Operation
- Introduction
- Before you operate the product
- Fuel
- Work position
- Correct balance of the product
- To prepare the product for start
- To start the product
- To start with a throttle handle with a start throttle lock
- To stop the product
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- Grass clearing with a grass blade
- Grass trimming with a trimmer head
- Maintenance
- Introduction
- Maintenance schedule
- To clean the cooling system
- To do a check of the muffler
- Air filter
- To clean the air filter
- To apply oil to the air filter
- Bevel gear
- To attach and remove the locknut
- To examine the spark plug
- To adjust the engine
- To adjust the low speed needle (L)
- To adjust the high speed needle (H)
- To adjust the start throttle speed
- To adjust the idle speed
- To sharpen the grass knife and grass blade
- To sharpen the saw blade
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
- EC Declaration of Conformity
3. Turn the output shaft to align one of the holes in the
drive disc with the related hole in the gear housing.
4.
Put the locking pin (C) in the hole to lock the shaft.
5. Turn the trimmer head/plastic blades (H)
counterclockwise to attach.
B
H
P
C
To attach the guard extension
CAUTION: Use the guard extension when
you use a trimmer head/plastic blade. Do
not use the guard extension when you use a
grass blade.
1. Put the guard extension in the groove of the cutting
attachment guard.
2. Put the guard extension into position on the cutting
attachment guard with the 4 locking hooks.
To remove the guard extension
•
Release the locking hooks with the spark plug
wrench.
To attach the grass blade and the grass blade
guard/combination guard
1.
Put the blade guard/combination guard (A) onto the
shaft and tighten the bolt to attach it.
A
2. Make sure that the guard extension is removed.
3.
Turn the output shaft to align one of the holes in the
drive disc (B) with the related hole in the gear
housing.
4. Put the locking pin (C) in the hole to lock the shaft.
5. Put the grass blade (D), the support cup (E) and the
support flange (F) on the output shaft.
G
F
D
B
C
A
E
6. Make sure that the drive disc and support flange
engages correctly in the centre hole of the grass
blade.
7. Attach the nut (G).
12 1069 - 005 -