Trimmer Operator's Manual

ASSEMBLY

English – 15

CAUTION! Use the recommended blade guard. See

the Technical data section.

• Fit the drive disc (B) on the output shaft.

• Turn the blade shaft until one of the holes in the drive

disc aligns with the corresponding hole in the gear

housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Place the blade (D) and support ﬂange (F) on the

output shaft.

• Fit the nut (G). The nut must be tightened to a torque

of 35-50 Nm (3.5-5 kpm). Use the socket spanner in

the tool kit. Hold the shaft of the spanner as close to

the blade guard as possible. To tighten the nut, turn

the spanner in the opposite direction to the direction

of rotation (Caution! left-hand thread).

• When loosening and tightening the saw blade nut,

there is a risk of injury from the teeth of the saw blade.

You should therefore always ensure that your hand is

shielded by the blade guard when doing this. Always

use a socket spanner with a shaft that is long enough

to allow this. The arrow in the diagram shows the area

where you should operate the socket spanner when

loosening or tightening the nut.

Fitting other guards and cutting

attachments

• Fit the trimmer guard/combination guard (A) intended

for use with the trimmer head/plastic blades. Hook the

guard onto the ﬁtting on the shaft and secure it with

the bolt (L).

• Fit the drive disc (B) on the output shaft.

• Turn the blade shaft until one of the holes in the drive

disc aligns with the corresponding hole in the gear

housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Screw on the trimmer head/plastic blades (H) in the

opposite direction to the direction of rotation.

• To dismantle, follow the instructions in the reverse

order.