Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Important
- Personal protective equipment
- Machine¢s safety equipment
- Cutting equipment
- Fitting the handlebar (323RII)
- Fitting the handlebar (327Rx, 327RDx)
- Assembling and dismantling the two-piece shaft (327RDx)
- Assembling the cutting equipment
- Fitting a blade guard, grass blade and grass cutter
- Fitting the blade guard and saw blade
- Fitting other guards and cutting attachments
- Adjusting the harness and brush cutter
- Standard harness
- Fuel safety
- Fuel
- Fuelling
- Check before starting
- Starting and stopping
- General working instructions
- Carburettor
- Muffler
- Cooling system
- Bevel gear
- Air filter
- Two-piece shaft (327RDx)
- Spark plug
- Maintenance schedule
- Technical data
- EC-declaration of conformity (Applies to Europe only)
ASSEMBLY
English – 13
Fitting the handlebar (323RII)
• Remove the screw at the rear of the throttle handle.
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole
in the handlebar.
• Refit the screw in the hole in the rear of the throttle
handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Unscrew the knob from the handlebar mounting.
• Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness. Tighten the knob.
Fitting the handlebar (327Rx,
327RDx)
• Remove the screw at the rear of the throttle handle.
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole
in the handlebar.
• Refit the screw in the hole in the rear of the throttle
handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Unscrew the knob from the handlebar mounting.