Hedge Trimmer Operator's Manual

16 – English
WORKING TECHNIQUES
If anything jams in the blades while you are working,
switch off the engine and wait until it has stopped
completely before cleaning the blades. Disconnect the HT
lead from the spark plug.
Safety instructions after completing work
The transport guard should always be tted to the cutting
attachment when the machine is not in use.
Make sure the cutting attachment has stopped before
cleaning, carrying out repairs or an inspection.
Disconnect the HT lead from the spark plug.
Always wear heavy-duty gloves when repairing the cutting
attachment. This is extremely sharp and can easily cause
cuts.
Store the machine out of reach of children.
Use only original spare parts for repairs.
Basic working techniques
Work with a swinging action from the bottom upwards
when trimming sides.
Adjust the throttle setting to suit the load.
When trimming a hedge the engine should always face
away from the hedge.
Hold the machine as close to your body as possible to get
the best balance.
Make sure that the tip does not touch the ground.
Do not rush the work, but work steadily until all the
branches have been cut back cleanly.
Changing the hedge trimmer angle
(323HE3, 325HE3,325HE4)
Undo the knob.
Grasp the handle on the angle stop, adjust to the desired
angle and then tighten the knob.
(325HDA55)
Undo the knob.
Press the cutting head against the ground or some other
solid object until the desired angle has been obtained.
Tighten the knob.
!
WARNING! Do not hold the cutting head
when you adjust the angle. The blades are
sharp and you could easily cut yourself.