325 LX Clean Sweep Assembly Secure the drum axle 2 to the shaft Clevis Pin Hitch Pin Install drum Drum Axle output shaft Cotter Pin 4 Secure with a cotter pin the sweeper 3 Install drum assembly Drum Assembly 1. Push one of the drum axles onto 4. Use a cotter pin to secure the drum either of the two gearcase output assembly on the axle (see inset). shafts.
Break-in and Operation If the machine is used in dusty conditions, the air filter should be saturated in air filter oil (see "Oiling the Air Filter" in the operators manual that came with the powerhead). Please check and clean the air filter often and replace the filter when necessary to prevent damage. ALWAYS wear hearing protective devices. The Properly Dressed Operator ALWAYS wear eye protection such as goggles or safety glasses. ALWAYS wear a mask to protect against dust or other airborne particles.
Operating Techniques Operate the Clean Sweep at or near full throttle with its sweeper fins resting on the work surface. IMPORTANT! It is both tiring and unnecessary to lift or hold the fins from the work surface during sweeping. OPERATION When sweeping narrow areas such as sidewalks, the Clean Sweep can be used to throw material directly ahead of the operator. Clearing wider areas may require sweeping at an angle to create windrows to one side of the path being cleared.
Operating and Safety Tips Maintain a shallow working angle. A steep working angle risks loss of control! OPERATION WARNING! Maintain a shallow angle to the work surface! A high angle of operation tends to propel the broom toward you, risking loss of control of the machine. The sweeper belts may rotate when the Clean Sweep is started! Always maintain a firm grip when starting the Clean Sweep. Beware of objects that could become entangled in or be thrown by the rotating sweeper belts.
Husqvarna Printed in U.S.A.