Lawn Mower User Manual

16 – English

Driving

Cutting tips

• Localise and mark stones and other ﬁxed objects to avoid

collision.

• Start with a high cutting height and reduce down until the

required mowing results are obtained.

• The mowing result will be best with the highest permitted

engine speed, see technical data, (the blades rotate

rapidly) and low speed (the Mower moves slowly). If the

grass is not too high and thick, the driving speed can be

increased without noticeably depreciating the mowing

result.

• The best lawns are achieved if the grass is cut often.

Mowing becomes more uniform and the grass cuttings

become more evenly distributed over the surface. The

total time consumption is not greater since it is possible to

select a higher driving speed without inferior mowing

results.

• Avoid mowing a wet lawn. The mowing results are inferior

since the wheels sink down into the soft lawn.

• Hose down the cutting unit with water underneath each

time it is used. The cutting unit should then be put in the

service position.

• When the BioClip function is used, it is very important that

the mowing interval is not too long.

Stop the engine

Preferably allow the engine to idle for a minute to obtain

normal working temperature before stopping it if it has been

working hard. Avoid idling the engine for long periods, as

there is a risk of carbon build-up on the spark plugs.

1 Lift up the cutting unit by pulling the lever backwards to its

locked position.

1 Pull back the throttle and turn the ignition key to the

”STOP” position.

2 When the Rider is at a standstill, press down the parking

brake and push in the locking button.

WARNING! Clear the lawn from stones and

other objects which can be thrown out by

the blades.

WARNING! Do not use the machine on

ground that slopes more than 10

°°

Mow

slopes upwards and downwards, never

across. Avoid sudden changes in direction.