Huawei-EG860-User-Guide-V200R003C00-02
Table Of Contents
- About This Document
- Contents
- 1 Change History
- 2 Introduction
- 3 Hardware
- 4 Installation
- 5 Configuration
- 6 Maintenance
- 7 Reference
- 7.1 Status
- 7.2 General Settings
- 7.3 Security Settings
- 7.4 NAT Settings
- 7.5 QoS Management
- 7.6 VPN
- 7.7 System
- 7.7.1 Device Information
- 7.7.2 Reset
- 7.7.3 Backup & Recovery
- 7.7.4 Upgrade
- 7.7.5 Password Change
- 7.7.6 Password Complexity
- 7.7.7 Password security Settings
- 7.7.8 Date & Time
- 7.7.9 Diagnosis
- 7.7.10 Log
- 7.7.11 Device Switch
- 7.7.12 Bandinfo Number Configuration
- 7.7.13 Work Frequency
- 7.7.14 SIM Configuration
- 7.7.15 Alarm Configuration
- 7.8 Logout
- 8 Alarm Reference
- 9 Glossary
Index Application name Source Address
Range
Destination
Address Range
2 Custom 122.22.22.71 191.162.1.3
3 Custom 191.162.1.3 122.22.22.71
4 Custom 192.168.71.1 184.1.5.10
5 Custom 184.1.5.10 192.168.71.1
NOTE
l 192.168.71.5 is the IP address of PC for EG860 local maintenance
l 192.168.71.1 is the IP address of the attached camera of EG860
l 192.168.71.10 is the IP address for logging into the EG860 WebUI
l 122.22.22.71 is the IP address allocated by the core network to the WAN port on theEG860
l 191.162.1.3 is the service IP address of the eOMC910
l 184.1.5.10 is the IP address of the Dispatcher
The above IP addresses are for reference only. Please configure them according to the actual networking
plan.
7.4 NAT Settings
Network Address Translation (NAT) settings, or port mapping settings, is necessary if a PC
server is enabled and used by a WLAN, to allow port redirection for access from the WLAN to
the server.
Procedure
Step 1 Choose NAT Settings > Port Mapping. The Port Mapping page is displayed.
Step 2 Click Add Item to configure the parameters in Port Mapping.
The related parameters are as follows:
l Type: indicates the type of the preset port mapping template. It is a configuration wizard.
When the value of Type is Custom, other parameters needed to be filled in manually. Set
according to the plan. When setting as other types, the default configuration is applied.
l Protocol: indicates the Protocol used for port mapping.
l Remote Host: indicates that only the authorized IP addresses are allowed to access the
WLAN.
l Remote Port Range: indicates the port number of remote host. It must be a single number
or a range within the range from 1 to 65535.
l Local Host: indicates the IP address of the server within the LAN.
l Local Port: indicates the port number of local host. It must be a single number or a range
within the range from 1 to 65535.When this parameter is null, by default, the Local Port and
Remote Port Range are the same. For example, the value of Remote Port Range is 23, the
value of Local Port is also23.
EG860
User Guide
7 Reference
Issue 02 (2015-04-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
94