Product Data Sheet / Brochure

QuickSpecs
HPE ProLiant DL380 Gen10 Server
Standard Features
Page
12
Secondary Riser
Slots #
Technology
Bus Width
Connector Width
Slot Form Factor
Notes
1
PCIe 3.0
X8
X8
Full-height, full-length slot
Proc 2
2
PCIe 3.0
X16
X16
Full-height, full-length slot
Proc 2
3
PCIe 3.0
X8
X8
Full-height, half-length slot
Proc 2
NOTE: Bus Width Indicates the number of physical electrical lanes running to the connector.
NOTE: The Secondary Riser requires Processor 2 to be populated 870548-B21
NOTE: The specifications above correspond with the x8/x16/x8 Secondary Riser Kit (870548-B21). Additional Secondary Riser
options and specifications noted in the “Riser Information” table within this document.
Tertiary Riser
Slots #
Technology
Bus Width
Connector Width
Slot Form Factor
Notes
1
PCIe 3.0
X8
X8
Full-height, full-length slot
Proc 2
2
PCIe 3.0
X8
X8
Full-height, full-length slot
Proc 2
NOTE: Bus Width Indicates the number of physical electrical lanes running to the connector.
NOTE: The Tertiary Riser requires Processor 2 to be populated
NOTE: The specifications above correspond with the 2x8 Tertiary Riser Kit (875780-B21). Additional Tertiary Riser options
and
specifications noted in the “Riser Information” table within this document
Storage Controllers
The Gen10 controller naming framework has been updated to simplify identification as depicted below. For a more detailed brea
kout
of the available Gen10 Smart Array controllers visit the HPE Smart Array Gen10 Controllers Data Sheet.
One of the following
depending on model
Software RAID
HPE Smart Array S100i SR Gen10 SW RAID
NOTE: HPE Smart Array S100i SR Gen10 SW RAID will operate in UEFI mode only. For legacy support an
additional controller will
be needed, and for CTO orders please also select the Legacy mode settings part, 758959-B22.
NOTE: HPE Smart Array S100i SR Gen10 SW RAID is off by default and must be enabled.
NOTE: The S100i uses 14 embedded SATA ports, but onl
y 12 ports are accessible as 2 are leveraged to support the 2 M.2 options
on the primary riser.
NOTE: The S100i supports windows only
NOTE: For Linux users, HPE offers a solution that uses in-distro open-source software to create a two-disk RAID 1 boot vol
ume.
For more information visit:
https://downloads.linux.hpe.com/SDR/project/lsrrb/
Essential RAID Controller
• HPE Smart Array E208i-a SR Gen10 Controller
• HPE Smart Array E208i-p SR Gen10 Controller
• HPE Smart Array E208e-p SR Gen10 Controller
Performance RAID Controller
• HPE Smart Array P408i-a SR Gen10 Controller
• HPE Smart Array P408i-p SR Gen10 Controller
• HPE Smart Array P408e-p SR Gen10 Controller
• HPE Smart Array P816i-a SR Gen10 Controller
NOTE: Performance RAID Controllers require the HPE Smart Hybrid Capacitor (P02377-B21) or the HPE Smart Storage Battery
(P01366-B21) which are sold separately.
NOTE: For additional details, please see HPE Smart Array Gen10 Controllers Data Sheet.