ProLiant DL360 Gen10 Server

QuickSpecs
HPE ProLiant DL360 Gen10 Server
Technical Specifications
Page 49
System Unit
Dimensions
(Height x Width x Depth)
4.29 x 43.46 x 70.7 cm
1.69 x 17.11 x 27.83 in
SFF Drives
4.29 x 43.46 x 74.98 cm
1.69 x 17.11 x 29.5 in
LFF Drives
Weight (approximate)
13.04 kg
28.74 lb
SFF minimum: One drive, one processor, one power supply, two
heatsinks, one Smart Array controller, and five fans.
16.27 kg
35.86 lb
SFF maximum: 10 drives, two processors, two power supplies, two
heatsinks, one Smart Array controller and seven fans.
13.77 kg
30.36 lb
LFF minimum: one drive, one processor, one power supply, two
heatsinks, one Smart Array controller and five fans.
16.78 kg
37 lb
LFF maximum: Four drives, two processors, two power supplies, two
heatsinks, one Smart Array controller and seven fans.
Input Requirements
(per power supply)
Rated Line Voltage
100 to 120 VAC
200 to 240 VAC
BTU Rating
Maximum
For 800W Power Supply: 3207 BTU/hr (at 100 VAC), 3071 BTU/hr
(at 200 VAC), 3112 BTU/hr (at 240 VDC) for China Only
For 500W Power Supply: 1979 BTU/hr (at 100 VAC), 1911 BTU/hr
(at 200 VAC), 1965 BTU/hr (at 240 VDC) for China Only
Power Supply Output
(per power supply)
Rated Steady-State
Power
For 1600W Power Supply: 1600W (at 240 VAC), 1600W (at 240
VDC) for China only
For 800W Power Supply: 800W (at 100 VAC), 800W (at 240 VAC),
800W (at 240 VDC) input for China only
For 500W Power Supply: 500W (at 100 VAC), 500W (at 240 VAC),
500W (at 240 VDC) input for China only
Maximum Peak Power
For 1600W Power Supply: 1600W (at 200 to 240 1VAC), 1600W (at
240 VDC) input for China only
System Inlet Temperature
Standard Operating
Support
10° to 35°C (50° to 95°F) at sea level with an altitude derating of
1.0°C per every 305 m (1.8°F per every 1000 ft) above sea level to a
maximum of 3050 m (10,000 ft), no direct sustained sunlight.
Maximum rate of change is 20°C/hr (36°F/hr). The upper limit and
rate of change may be limited by the type and number of options
installed.
System performance during standard operating support may be
reduced if operating with a fan fault or above 30°C (86°F).
For approved hardware configurations, the supported system inlet
range is extended to be: 5° to 10°C (41° to 50°F) and 35° to 40°C
(95° to 104°F) at sea level with an altitude derating of 1.0°C per
every 175 m (1.8°F per every 574 ft) above 900 m (2953 ft) to a
maximum of 3050 m (10,000 ft). The approved hardware
configurations for this system are listed at the URL:
http://www.hpe.com/servers/ashrae