HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays 3.00.00 Installation and Reference Guide (AA-RW7SJ-TE, March 2008)
hpdsm devices a
ll
Syntax: hpdsm devices all
The hpdsm devices all command displays information of the device, followed by their path
information as
shown in the following example. If there are no devices, the following message is
displayed: No devices found.
NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column s hows the device port,
bus, target, a
nd LUN.
Example:
hpdsm devices all
Device#
Device Name Serial No.
Active
Paths
Policy
Disk#
P.B.T.L ALB
1
HP HSV210 6005008B400101F6000170000 2
SQST
Disk1 4.0.2.3
N
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
1
P898DXAAQQO101U-2 Active
7
00010002 3.0.2.3
2 P898DXAAQQO101U-2 Active 6 00010002 4.0.2.3
Device#
Device Name Serial No.
Active
Paths
Policy
Disk#
P.B.T.L ALB
2 HP HSV210 6005008B400101F600018000 2
SQST
Disk2 3.0.2.4
N
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
1
P898DXAAQQO101U-2 Active
7
00010002 3.0.2.4
2 P898DXAAQQO101U-2 Active 6 00010002 4.0.2.4
hpdsm paths device
Syntax: hpdsm paths device=x
The hpdsm paths device command displays information about the paths available for device x,as
shown in the following example.
NOTE:
• The P.B.T.L. colum n shows the device port, bus, target, and LUN.
• TheRTPcolumnshowsthetargetportinformationasdefined by SCSI-3 specification.
• The Controller Port# column shows the controller serial number follow ed by target port number.
28
Managing storage arrays using the HP MPIO EVA DSM with the CLI utility