- Hewlett-Packard QMS 1660 Print System Reference Manual

The card slots are located on the right side of the printer below the
output tray. The printer supports up to two cards at once. You may insert
any type of card in either slot.
▲ Caution: Your printer supports only QMS PCMCIA cards. These
cards are
backward compatible with previously released QMS
printers, and cards for previous printers are
compatible with your
printer.
In addition, some cards may require that you add more memory to
your printer.
For a complete list of available font cards, contact your QMS vendor.
▲ Caution: The printer must be off line (the Online/Offline indicator is
off) before you insert or remove cards. Press the Online/Offline key
once to take the printer off line. If you insert a font card in one of the
card slots without taking the printer off line, the card will not be
recognized.
Use the following procedure to use a font card on your printer. If your
printer has a hard disk, you can install the font information from the
card onto your hard disk. See “Installing an Optional Font” later in this
chapter for instructions.
1 If you are using an HP ProCollection font card, turn off the
printer.
Otherwise, press the Online/Offline key to take the printer off
line. (The Online/Offline indicator should be off.)