Operation Manual

load paper

hp psc 2100 series

2 Tap the stack on a flat surface to align the edges of the paper, and

then check the paper for the following:

– Make sure it is free of rips, dust, wrinkles, and curled or bent

edges.

– Make sure all the paper in the stack is the same size and type,

unless you are working with photo paper.

3 Insert paper into the paper tray print-side down until it stops. If you are

using letterhead, insert the top of the page first.

Be careful not to use too much or too little paper. Check that the stack

of paper contains several sheets but is no higher than the top of the

paper-length guide.

4 Slide the paper-width and paper-length guides in until they stop at the

edges of the paper. Make sure that the paper stack lies flat in the

paper tray and fits under the tab of the paper-length guide.

5 Replace the output tray.