- Hewlett-Packard All in One Printer User Manual

2-23
Installation and Configuration
Loading Envelopes in the Input (Paper) Tray
SL8
SL9
12
34
Slide the green paper guide until it snaps into
place at the appropriate envelope size setting.
The envelope guide will pop up to keep the
envelopes vertically aligned. Install the output
tray if not already installed.
Paper Guide
Pull the input tray out until it is fully extended.
The user can remove the output tray to facilitate
envelope loading as shown in this procedure. Be
sure to install the output tray before printing.
Helpful Hints:
Do not force the input tray all the way in when
closing it. The envelopes must not buckle or a
paper jam could occur.
Load up to 20 envelopes flap up, with the
top edge aligned to the right side of the
HP OfficeJet Series 300, as shown.
U.S. No. 10
envelope
European DL
envelope
The following table lists the two allowable
envelope sizes. Note that copies cannot be
made and faxes cannot be received on any
envelopes. Be sure to set the paper size in the
menu to envelopes before printing.
Description Size
European DL
envelopes 8.66x4.33 inches (220x110mm)
U.S. No. 10
envelopes 9.5 x4.12 inches (241x105 mm)
SL7
An “out of fax paper” error will display on the
front panel card of the HP OfficeJet Manager, if
it is open. Although the device is unable to de-
tect the presence of envelopes even when prop-
erly loaded, it will print them.
Install the output tray. If necessary refer to
“Installing an Output Tray” earlier in this
chapter.