Manual

Silo Media Manager Installation and Users Guide
Hardware and Software Installation for the Client
3-6
3.5.3 CONFIG_HOSTPORT#
The host port number needs to be configured to successfully run the client. To
configure or change the host port number, type “CONFIG_HOSTPORT#” and press
enter. Enter the port number of the system where the silo resides when prompted to
do so. Once the host port number has been entered, the new configuration will be
shown and confirmation will be requested. Type “Y,” and the main menu prompt
will return.
3.5.4 CONFIG_HOSTIP
Once the host port number has been configured, the host IP address needs to be
configured. Type “CONFIG_HOSTIP” to add or change the IP address of the
system where the silo resides at the main menu prompt and press enter. Enter the
host IP address at the designated prompt. Once the new address has been entered, the
new configuration will be shown and again confirmation will be requested. Type “Y”
to return to the main menu prompt.
3.5.5 ALTER_PASSWORD
Type “ALTER_PASSWORD” to change the password. Follow the prompts to
change the password.
3.5.6 EXIT
To exit the configuration menu, type “EXIT” at the main menu prompt.
3.6 Running the Processes on the Client
Note: The processes on the Server must be running before running the processes on
the Client!
Once the client has been configured, the process will need to be executed before
connecting to the robot using the GUI. To run the client, exit the configuration menu
by typing “EXIT” at the prompt. At the TACL prompt, type RUN
TSIMMC0/NAME $CLT2, NOWAIT, TERM $TRM0.#A, OUT, $TRM0.#A/ and
press enter. It should look something like the box below.
TACL prompt> RUN TSIMMC0/NAME $CLT2, NOWAIT, TERM $TRM0.#A, OUT, $TRM0.#A/