Fibre Channel Thermal Upgrade Kit

910
Position the outside edge of the thermal upgrade
kit cover as shown and lower it towards the unit.
Connect the card cage fan's other cable to the
fan on the thermal upgrade kit cover.
11 12
When the cover lies flat on top of the unit, slide it
back to align the mounting holes. Replace the
11 screws to secure the new right rear cover.
Replace the 2 screws to replace the top cover.
13 14
For rack mounted libraries, reinstall the library
into the rack. For table top libraries, replace
the outer cover. See the HP StorageWorks
MSL5000 and 6000 Series Tape Library User
Guide detailed instructions.
Replace the left side tape cartridge magazine
and close the door. Proceed to the HP
StorageWorks Network Storage Router kit
installation instructions.
1 inch (2.54 cm)
Connect the card cage replacement fan 3-pin
connector to the card cage backplane at the J11
location.
Make sure that
the fan power
cables do not
bind between
the cover and
the top of the
library chassis.
Note: As the cover is lowered, offset
the rear edge of the cover approximately
1 inch in front of the rear edge of the library.
This enables you to slide the cooling
fan/baffle under the outer lip of the library.
J11