User's Manual

HP R100-Series Wireless VPN Routers Quickstart 6 Products list
6. Confirm the settings, and then click Finish.
The router reboots and the HP R110/R120 is operational.
E. Test the wireless connection
For the purposes of this example, the HP R110/R120 has its DHCP server
enabled (the default setting) and the cable modem is on and operating normally.
1. Disconnect the wired connection from your computer to the HP R110/
R120.
2. Enable the wireless network interface of your computer.
3. Use your computer’s wireless network utility to find and connect to the
HP R110/R120’s wireless network. The SSID name is “HP” in this
example.
4. When prompted, enter the wireless security passphrase for the network,
as configured in section D, step 5.
5. Confirm that you can browse the Internet from your computer.
F. To perform additional configuration
Re-launch the HP R110/R120 management interface at https://192.168.1.1 and
log in using the configured username and password.
Products list
WW=Worldwide, AM=The Americas (North, Central, and South America)
Technical support
For worldwide technical support information, see the HP support website at
www.hp.com/networking/support.
Regulatory information
FCC Notice
FCC ID
:
R110: B94MRLBB1401
R120: B94MRLBB1402 & B94MRLBB1403
This FCC Class B device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may cause
undesired operation.
For the full FCC Class B equipment notice and other important safety, environmental, and
regulatory information, see
Safety and Compliance Information for Server, Storage,
Power, Networking, and Rack Products
, available at www.hp.com/support/Safety-
Compliance-EnterpriseProducts.
For products available in the USA/Canada market, 2.4 GHz operation is limited to
channels 1-11.
When this device is operated in 5.15-5.25 GHz frequency range, it is restricted to indoor
use only.
This device will not permit operation on channels 120-132 for 11
a, 11n and 11ac modes
that overlap the 5600-5650 MHz band.
A 20 cm minimum distance must be maintained between the antenna and the users of
this wireless device. Under such configuration, the FCC radiation exposure limits set forth
for a population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate this equipment.
Industry Canada Notice
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
Users should also be advised that high-power radars are allocated as primary users (i.e.
priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars
could cause interference and/or damage to LE-LAN devices.
Model Part numbers
HP R110 J9975A (WW), J9974A (AM)
HP R120 J9977A (WW), J9976A (AM)
This device and it's antennas(s) must not be co-located or operating in conjunction with any
other antenna or transmitter except in accordance with IC multi-transmitter product
procedures.