HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 395
Error Messages and Warnings
Installer Error Messages (INSTERR)
Cause Patch Selector failed while trying to access the appropriate
FILEINFO.
Action • Document all messages prior to the error.
• Note names of all F@.INSTALL.SYS files.
• Save the HPSWINFO.PUB.SYS,
PATCHAUD.INSTALL.SYS, and
INSTERRS.INSTALL.SYS files.
• Report the problem to the Response Center for
assistance.
# Message Failed to convert the CHECKSUM from FILEINFO
file. (INSTERR
#131)
Cause A call to the intrinsic DBINARY failed.
Action If this error is produced, please document all messages
prior to the error. Save the file PATCHAUD.INSTALL and
the file INSTERRS.INSTALL, and then report the
problem to the Response Center for assistance.
132 Message Failed to access the SLTFEQ file. (INSTERR #132)
Cause CUSTOM failed either accessing a record from SLTFEQ,
reading SLTFEQ, or updating SLTFEQ.
Action • Document any error message text prior to the error.
• Purge SLTFEQ if it exists.
• Run HPINSTAL again from the beginning.
• Contact the Response Center if further assistance is
required.
133 Message The SLTFEQ file does not contain the name record.
(INSTERR #133)
Cause CUSTOM failed when attempting to replace a SYSPROG
file name in the SLTFEQ file with an OPT DRIVER file
name.
Action • Document any error message text prior to the error.
• Do a LISTF,3 on @INFO.INSTALL.SYS and
FSLTFEQ.INSTALL.SYS. All of the files should have
been created about the same time. If they were not,
follow the instructions in the installation guide to
perform initialization by using the SETUP process.
• Run HPINSTAL again.
• Contact the Response Center if further assistance is
required.
134 Message Installation requires 787,000 sectors of disk