HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 373
Error Messages and Warnings
Installer Error Messages (INSTERR)
intrinsic patcher ABLDINTX.INSTALL.SYS failed.
Action • FILE Command Table is possibly full.
• Check if any further file commands can be entered with
the FILE command.
• RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again. The installer will reissue any needed
file equations.
• Contact the Response Center if further assistance is
required.
57 Message Error trying to RUN ABLDINTX.INSTALL.SYS.
(INSTERR #57)
Cause Could not create ABLDINTX process. Createprocess error:
status
Action • The CREATEPROCESS intrinsic returned an error
status when attempting to execute
ABLDINTX.INSTALL.SYS.
• Check the returned CREATEPROCESS error in the
MPE/iX Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for
further errors.
• If ABLDINTX.INSTALL.SYS does not exist, restore
ABLDINTX.@.@ from the Powerpatch tape.
• Ensure INSTALL group has sufficient capabilities.
(need CAP=PH).
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
58 Message Error trying to RUN BUILDINT.PUB.SYS. (INSTERR
#58)
Cause Could not create BUILDINT process. Createprocess error:
status
Action • The CREATEPROCESS intrinsic returned an error
status when attempting to execute
BUILDINT.PUB.SYS.
• Check the returned CREATEPROCESS error in the
MPE/iX Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for
further errors.