HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 339
Error Messages and Warnings
SETUP Error Messages (SETERR)
SETUP Error Messages (SETERR)
1 Message You must be logged on to MANAGER.SYS,INSTALL to
set up for HPINSTAL. SETUP will terminate.
Follow the instructions in
your installation manual to continue. (SETERR
#1)
Cause You have either logged on as someone other than
MANAGER.SYS, or you are not in the INSTALL group.
Action • Log on as MANAGER.SYS,INSTALL and execute
SETUP.INSTUTIL.
• Contact the Response Center if further assistance is
required.
2 Message The group CD vuuff containing the HPINSTAL
fileset could not be initialized. SETUP will
terminate. Follow the instructions
in your installation manual to continue. (SETERR
#2)
Cause SETUP was unable to access the group CD vuuff .SYS on
the compact disk (CD-ROM) containing the HPINSTAL
file set.
Action • VSCLOSE the CD-ROM disk labelled volume 1
(MPE_C-45.00_1).
• PURGEGROUP CD vuuff
• VSOPEN the compact disk
• Execute SETUP.INSTUTIL
• If SETUP is still unable to initialize the CD vuuff .SYS
group, contact the Response Center for further
assistance.
3 Message The HPINSTAL data file, GRPNAMES, is
non-existent. SETUP
will terminate. Follow the instructions in your
installation manual
to continue. (SETERR #3)
Cause Either the file is non-existent, or SETUP is accessing the
file in an invalid location.
Action • Usethe LISTEQ commandto determine ifa file equation
exists. If it does exist, reset GRPNAMES.
• Execute SETUP.INSTUTIL.
• If GRPNAMES still cannot be located, contact the