HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 5 115
Modifying Your System
5.3 Listing the System Configuration
5.3 Listing the System Configuration
This section describes how to determine your system configuration group.
The factory System Load Tape (SLT) does not contain a default I/O configuration. During
an installation, you must specify the appropriate factory configuration group when
booting the system immediately after installing the factory SLT. Listing the system
configuration uses the off-line diagnostic tool, Mapper. To get help using MAPPER, type help
at the MAPPER prompt, and see Figure 5-1. for a sample listing.
To list the system configuration:
1. Check that all hardware peripherals are attached and powered on.
2. Start ODE.
ISL>ODE
3. Display hardware configuration.
ODE>RUN MAPPER
ODE>RUN MAPPER2 (for N-Class and A-Class systems)
The figure on the following page is a sample of a MAPPER display.
4. Record the I/O configuration for your system.
Find the MPE/XL Model String. Then refer to Appendix B , “Configuration Tables,” for
the configuration group name for your HP e3000 model in the SCSI column. For
example, for a Model 995, the SCSI group is CONFG995. It is very important to have
the exact group name. Check carefully for numbers zero and 1 and letters O and I.
5. Exit mapper.
ODE>EXIT
Figure 5-1. Sample Listing MAPPER Output
STARTING EXECUTION OF MAPPER
Processor Identification:
Hardware Model: 590H, Revision: 0
Software Model: 4H, Revision: 0
Hardware ID: 0, Software ID: 250911381 (unsigned decimal)
Software Cap: 0x10000031
MPE/XL Model String: 979-400
Processor Board Revisions:
CPU - CPU Chip: 769
PDC - Processor Dependent Code: 38.29
Cache and TLB Sizes:
Instruction Cache: 1024 K bytes, Instruction TLB: 96 entries
Data Cache: 1024 K bytes, Data TLB: 96 entries
Co-processors: