Operation Manual

EN
Chapter 4: Problem Solving 77
9410)'08'.12'
(''&'4+056#..'&
The envelope feeder you are trying to install will not work for this
printer.
Z2#2'4,#/
=.1%#6+10?
Remove jammed paper from the specified location.
Open and close the top cover to clear the message.
If the message persists after all jams have been cleared, a sensor
might be stuck or broken. Contact an HP-authorized service or
support provider. (See the HP Support pages at the front of this user’s
guide.)
+057((+%+'06
/'/14;
alternates with
24'55)161
%106+07'
The printer received more data than can fit in its available memory.
You might have tried to transfer too many macros, soft fonts, or
complex graphics.
Press [Go] to print the transferred data (some data might be lost),
then simplify the print job or install additional memory.
2#)'611
%1/2.':
alternates with
24'55)161
%106+07'
The data (dense text, rules, raster or vector graphics) sent to the
printer was too complex.
Press [Go] to print the transferred data. (Some data might be lost.)
To print the job without losing data, from the Configuration Menu in
the printer control panel, set
2#)'2416'%610
, print the job, and
then return
2#)'2416'%6#761
. Do not leave
2#)'
2416'%610
; it might degrade performance.
If this message appears often, simplify the print job.
'+1Z
$7(('418'4(.19
alternates with
24'55)161
%106+07'
Too much data was sent to the EIO card in the specified slot (
Z
). An
improper communications protocol may be in use.
Press [Go] to clear the message. (Data will be lost.)
Check the host configuration. If this message persists, contact an
HP-authorized service or support provider. (See the HP Support
pages at the front of this user’s guide.)
Printer Messages (Continued)
Message Explanation or Recommended Action