Operation Manual

100 Chapter 5 - Removal and replacement
EN
4 Release the two tabs (callout 1), one on each side of the shutter
lever, and lift the shutter lever straight up to remove it.
Note Make sure you do not misplace the small spring that is under the shutter
lever.
5 Remove four screws (callout 2) and then lift the assembly off of
the printer.
Figure 44. Removing the laser/scanner (2 of 2)
To reinstall
Insert the spring into the hole on the laser/scanner before you snap
the shutter lever back into place.
2
1
2
2