- Hewlett-Packard Printer User Guide

ENWW Checking the printer configuration 149
PCL or PS font list
Use the font lists to see which fonts are currently installed in the printer. (The font lists also show
which fonts are resident on a hard disk or flash DIMM.)
The PS font list shows the PS fonts installed, and gives a sample of those fonts. The following
describes the information that can be found on the PCL font list:
● Font gives the font names and samples.
● Pitch/Point indicates the pitch and point size of the font.
● Escape Sequence (a PCL 5e programming command) is used to select the designated font.
(See the legend at the bottom of the font list page.)
● Font # is the number used to select fonts from the printer control panel (not the software
application). Do not confuse the font # with the font ID, described below. The number
indicates the DIMM slot where the font is stored.
• SOFT: Downloaded fonts that stay resident in the printer until other fonts are downloaded
to replace them or until the printer is turned off.
• INTERNAL: Fonts that permanently reside in the printer.
● Font ID is the number you assign to soft fonts when you download them through software.
1 Disk Information indicates the disk model number, serial number, capacity, available free
space, and whether you can write to the disk.
2 File Size column indicates the size of each file under the Directory/File Name column. If a
directory is listed on the line, then Directory appears in this column, and its path is listed in
the Directory/File Name column.
3 Directory/File Name indicates the name of the file. Files in a subdirectory are listed right
after the directory line. The files are not necessarily listed in alphabetic order.