Operation Manual

To reserve and lock out Trays:
This procedure does the following:
• Changes the configuration of Tray 1 from the primary printing source
(TRAY 1=FIRST) to a reserved printing source (TRAY 1=CASSETTE),
and specifies a media size.
• Selects a size for Tray 1 from the control panel.
Locking Tray 1
1 Press [Menu] until CONFIG MENU appears.
2 Press [Item] until TRAY 1=setting appears.
3 Press [- Value +] until TRAY 1=CASS ETTE appears, then press [Select].
4 Press [Item] until LOCK TRAY=NON E appears.
5 Press [- Value +] until LOCK TRAY=1 appears, then press [Select] to
save your selection.
6 Press [Item] until SIZE 1=setting appears.
7 Press [- Value +] until the desired size of paper you have selected
appears, then press [Select].
8 Press [Go] to place the printer back on line.
9 Place a stack of paper into Tray 1.
Tray 1 is now locked out from automatic selection. The printer will not
draw from Tray 1 unless it is selected through a software application.
Locking Tray 2 and Optional Tray 3
• To reserve and lock out Tray 2 when no Tray 3 is present, first
change the configuration of Tray 1 to TRAY 1=CASSETTE (follow
steps 1-3).
• Tray 2 and the optional Tray 3 are locked out the same way as Tray 1
(follow steps 4 through 8).
4
Printing
EN Printing 4-11