- Hewlett-Packard LaserJet Printer User's Guide

28 Chapter 2: Printing Tasks
EN
Loading Trays 2 and 3 (4000 T/4000 TN)
Trays 2 and 3 are 250-sheet trays. For
supported sizes of paper, see
page A-4. Choose A5 and B5 ISO as
custom sizes in the printer driver for
these trays (page 45).
Note
To avoid paper jams, do not load trays
while the printer is printing.
1
Pull the tray completely out of the
printer.
2
If the tray is not already set to the
desired paper size, snap the left and
right guides into place to match the
width of the paper.
3
Locate the release tabs (indicated
by the two arrows).
Squeeze the blue tabs to release
them from the slots while sliding the
back section of the tray to the
desired paper size. Make sure the
tabs lock into the correct slots.
4
Load paper into the tray.
5
Make sure the paper is flat in the tray
at all four corners and below the tabs
on the guides. Gently slide the tray
back into the printer.
The printer senses the size of paper
loaded if the tray is adjusted correctly.
To print by type and size of paper, see
page 52.