- Hewlett-Packard Printers Service Manual
Table Of Contents
- Contents
- Chapter 1 Printer Description
- Chapter 2 Service Approach
- Chapter 3 Printer Operation
- Chapter 4 Printer Maintenance
- Chapter 5 Functional Information
- Chapter 6 Removing and Replacing Parts
- Overview
- Removal and Replacement Strategy
- Removing Covers
- Removing Assemblies
- Separating the Engine Module from the Paper Feed M...
- Engine Controller Board
- Paper Feed Rollers
- Separation Rollers
- Paper Feed Module Plate
- Paper Feed Module Gear Train Assembly
- Paper Feed Module Side Rails
- Lower Paper Feed Module Plate (HPLaserJet 4000T/...
- PCA Cover (HPLaserJet 4000T/4000TN and 4050T/4...
- PCA Cover (HPLaserJet 4000/4000N and 4050/4050N...
- PCA Controller
- Chapter 7 Troubleshooting
- Chapter 8 Parts and Diagrams
- Index
4-4 Printer Maintenance
Using the Printer Cleaning Page
If Toner specks appear on the front or back side of your print jobs,
follow the procedure below.
From the printer’s Control Panel, do the following:
1 Press [Menu] until
PRINT QUALITY MENU
appears.
2 Press [Item] until
CREATE CLEANING PAGE
appears.
3 Press [Select] to create the cleaning page.
4 Follow the instructions on the cleaning page to complete the
cleaning process.
Note In order for the cleaning page to work properly, print the page on copier
grade paper (not bond or rough paper).
You might need to create a cleaning page more than once. When
Toner has been cleaned from the Fuser Assembly, shiny black spots
will appear on the page’s black strip.
To ensure good print quality with certain types of paper, use the
cleaning page every time the Toner Cartridge is replaced. If the
cleaning page is frequently needed, try a different type of paper.
Cleaning Spilled Toner
Defective Toner Cartridges can develop leaks. Also, after a paper jam
has occurred, there may be some Toner remaining on the rollers and
guides inside the printer. The pages that print immediately after the
jam may pick up this Toner.
Clean spilled Toner with a cloth dampened with cold water. Do not
touch the Transfer Roller with the damp cloth or with your fingers.
Do not use a vacuum cleaner unless it is equipped with a micro-fine
particle filter.