- Hewlett-Packard Printers Service Manual
Table Of Contents
- Contents
- Chapter 1 Printer Description
- Chapter 2 Service Approach
- Chapter 3 Printer Operation
- Chapter 4 Printer Maintenance
- Chapter 5 Functional Information
- Chapter 6 Removing and Replacing Parts
- Overview
- Removal and Replacement Strategy
- Removing Covers
- Removing Assemblies
- Separating the Engine Module from the Paper Feed M...
- Engine Controller Board
- Paper Feed Rollers
- Separation Rollers
- Paper Feed Module Plate
- Paper Feed Module Gear Train Assembly
- Paper Feed Module Side Rails
- Lower Paper Feed Module Plate (HPLaserJet 4000T/...
- PCA Cover (HPLaserJet 4000T/4000TN and 4050T/4...
- PCA Cover (HPLaserJet 4000/4000N and 4050/4050N...
- PCA Controller
- Chapter 7 Troubleshooting
- Chapter 8 Parts and Diagrams
- Index
Separating the Engine Module from the Paper Feed Module 6-45
Facing the front of the Engine Module:
3 Remove 7 screws (shown in Figure 6-41 on page 6-44):
• 4 black, self-tapping M4 screws (3 in front and 1 in the right
rear)
• From the left rear, 3 M3 screws (1 recessed)
4 Disconnect the spring on the right side from the notch.
5 Disconnect the Power Switch Rod.
Figure 6-42 Removing the Engine Controller Board
6 Lifting from the printer’s left side (the side the Fan is on), tip the
board up, then unplug all connectors.
Hint The black cable router in the middle of the Engine Controller Board can
be folded aside with the cables intact. When you replace the board,
reconnect and route all cables before reconnecting the power switch
rod.
Be sure to reconnect the spring on the right side to the Ground Plate.