- Hewlett-Packard LaserJet Owner's Manual

158 B Control panel menus ENWW
DHCP settings DHCP RELEASE
*NO
YES
This menu appears if CONFIG METHOD is set to DHCP and a
DHCP lease for the print server exists.
NO (default): The current DHCP lease is saved.
YES: The current DHCP lease along with the leased IP
address are released.
DHCP RENEW
*NO
YES
This menu appears if CONFIG METHOD is set to DHCP and
a DHCP lease for the print server exists.
NO (default): The print server does not request to renew the
DHCP lease.
YES: The print server requests to renew the current DHCP
lease.
Manual settings IP ADDRESS
n.n.n.n
The unique IP address of the printer, where n is a value
from 0 to 255.
SUBNET MASK
m.m.m.m
The subnet mask for the printer, where m is a value from 0
to 255. The mask is applied to IP addresses to uniquely
identify subnetworks and nodes.
SYSLOG SERVER
n.n.n.n
The IP address of the syslog server used to receive and log
syslog messages.
DEFAULT
GATEWAY
n.n.n.n
The IP address of the gateway or route used for
communications with other networks.
IDLE TIMEOUT
XX
The timeout value (in seconds) before an idle TCP print
data connection is automatically closed. The default value
is 270 seconds. 0 disables the timeout.
IPX/SPX There is no value to select.
ENABLE OFF
*ON
Select whether the IPX/SPX protocol stack (in Novell
NetWare networks, for example) is enabled or disabled.
FRAME TYPE *AUTO
EN_8023
EN_II
EN_SNAP
TR_8022
TR_SNAP
Select the frame type setting for your network.
AUTO (default): Automatically sets and limits the frame type
to the first one detected.
For an Ethernet network only, frame type selections include
EN_8023, EN_II, EN_8022, and EN_SNAP.
For a Token Ring network only, frame type selections
include TR_8022 and TR_SNAP.
SOURCE ROUTING *AUTO
OFF
ALL ROUTES
SINGLE ROUTE
For a Token Ring network only, specify the NetWare Token
Ring Source Routing parameter.
AUTO (default): The type of source routing required on the
network is automatically sensed.
OFF: All packets are sent without source routing, and only
packets from the same ring are received.
ALL ROUTES and SINGLE ROUTE: All packets are sent with
source routing (broadcasts and when the route is
unknown).
APPLETALK There is no value to select.
ENABLE OFF
*ON
For an Ethernet network only, select whether the AppleTalk
protocol stack is enabled or disabled.
DLC/LLC There is no value to select.
ENABLE OFF
*ON
Select whether the DLC/LLC protocol stack is enabled or
disabled.
Item Values Explanation