- Hewlett-Packard Printer User Manual

Specifications and Regulatory Statements 47
ENWW
FCC Class B for HP J7934A Ethernet or IEEE 802.3/802.3u. This equipment
has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
European Community
When used with Ethernet, IEEE 802.3/802.3u 10/100Base-TX
configurations, this equipment complies with EN55022 Class B (HP
J7934A) and Class A (J6057A).
J6057A Only: This is a class A product. In a domestic environment, this
product may cause radio interference, in which case the user may be
required to take adequate measures.
Declaration of Conformity. The following Declarations of Conformity
comply with ISO/IEC Guide 22 and EN45014. They identify the products,
the manufacturer's name and address, and the applicable specifications
that are recognized in the European community.
EIOSG.book Page 47 Thursday, October 9, 2003 1:42 PM