Safety Information

3
manufacturers or vendors with this device model may invalidate any approval or warranty
applicable to the device, result in the non-operation of the device, and cause danger.
Cleaning and Maintenance
It is normal that your wireless device gets hot when you use or charge it. Before you clean or
maintain the wireless device, stop all applications and disconnect the wireless device from
your PC.
 Use your wireless device and accessories with care and in a clean environment. Keep
the wireless device away from a fire or a lit cigarette.
 Protect your wireless device and accessories from water and vapor, and keep them dry.
 Do not drop, throw, or bend your wireless device.
 Clean your wireless device with a piece of damp and soft antistatic cloth. Do not use any
chemical detergent, powder, or other chemical agents (such as alcohol and benzene) to
clean the device.
 Keep the ambient temperature between -10℃ to +55℃ for using the device.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance.
 Note 1: This module has been certified to comply with RF exposure requirements under
mobile or fixed condition, this module is to be installed only in mobile or fixed applications.
The system antenna(s) used for this module must not exceed 2.5dBi.
 The transmitter module may not be co-located with any other transmitter or antenna. The
FCC ID label on the final system must be labeled with “Contains FCC ID:
B94-HWME206”.And
 As long as the above conditions are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed. To ensure
compliance with all non-transmitter functions the host manufacturer is responsible for
ensuring compliance with the module(s) installed and fully operational. For example, if a
host was previously authorized as an unintentional radiator under the Declaration of
Conformity procedure without a transmitter certified module and a module is added, the