HP XP7 Fast Snap User Guide (TK913-96003)

Cause of errorRAID Manager commandSSB2
The FS pair cannot be created because the FS P-VOL and BC P-VOL share the
volume, and the MU number you specified for the FS pair is already used by
the BC pair.
paircreate9774
The FS pair cannot be created because the FS P-VOL and BC S-VOL share the
volume, and you specified MU number zero (0) for the FS P-VOL.
paircreate9777
The command ended abnormally because the FS P-VOL and BC P-VOL share
the volume, and the BC pair was in the process of resynchronization.
paircreate, pairsplit977A
The command ended abnormally because the FS P-VOL and BC S-VOL share
the volume, and BC pair status is not P”SUS”.
paircreate, pairsplit977B
You cannot restore the FS pair because the FS P-VOL and BC P-VOL share the
volume, and BC pair is not split (“PSUS” status) or suspended and blocked
(“PSUE” status).
pairresync -restore977C
The FS pair cannot be restored because the FS P-VOL and BC S-VOL share the
volume, and BC pair is not split (“PSUS” status).
pairresync -restore977D
Snapshot data cannot be stored because the pool or the pool-VOL is blocked.pairsplit977E
You cannot restore the FS pair because of one of the following reasons:pairresync -restore9783
• You are storing snapshot data for the FS pair that you want to restore using
the consistency group to which the pair is assigned.
• You are using the P-VOL of the FS pair you want to restore as the P-VOL for
another FS pair, and you are storing the snapshot data of the latter pair using
the consistency group in which the pair is defined.
You cannot create the FS pair using the consistency group number because of
one of the following reasons:
paircreate978A
• BC is using the specified consistency group number.
• You have reached the maximum number of pairs that can be created for a
consistency group.
• A pair that uses the same P-VOL is assigned to the specified consistency
group.
You cannot create the FS pair because the consistency group number you
specified is not within range.
paircreate978B
You cannot create the FS pair because you have specified an THP V-VOL, which
is undergoing capacity expansion, as the FS P-VOL.
paircreate9790
You cannot create the FS pair because you have specified an THP V-VOL that
is reclaiming pages as the FS P-VOL.
paircreate9793
The command ended abnormally because you specified a volume that does not
have a path definition as the FS P-VOL.
paircreate, pairsplit,
pairresync, pairresync
-restore
9796
The command ended abnormally because you specified a volume that does not
have a path definition as the FS S-VOL.
paircreate, pairsplit,
pairresync, pairresync
-restore
9797
If you have reached the maximum number of FS pairs, you cannot create new
pairs.
paircreate97A1
The command ended abnormally because you specified a volume that uses two
mirrors in a three Cnt Ac-J data center configuration as the P-VOL.
paircreate, pairsplit,
pairresync,
pairresync-restore
97A2
The command ended abnormally because the volume specified as the S-VOL
uses two mirrors in a three Cnt Ac-J data center configuration.
paircreate, pairsplit,
pairresync,
pairresync-restore
97A3
Troubleshooting with RAID Manager 153