HP XP7 Business Continuity Manager Reference Guide (TK954-96004)

Table 52 Contents of the Copy Group Pair Detail Panel (continued)
DescriptionItem
SSIDSSID
CU numberCU
The two leftmost characters indicate the CCA of the device in hexadecimal.CCA
The rightmost character indicates, as follows, whether the CCA is an external
volume.
• +: An external volume
• -: Not an external volume
• (blank): The volume attribute is unknown because it was not requested.
Secondary DAD IDSec
Device number (modifiable)DevnSec
Storage system serial numberSN
Storage subsytem numberSSID
CU numberCU
The two leftmost characters indicate the CCA of the device in hexadecimal.CCA
The rightmost character indicates, as follows, whether the CCA is an external
volume.
• +: An external volume.
• -: Not an external volume.
• (blank): The volume attribute is unknown because it was not requested.
Displays the result of comparing the P-VOL and S-VOL capacities.CYL
• P: Displayed if the P-VOL capacity is larger than the S-VOL capacity
• S: Displayed if the S-VOL capacity is larger than the P-VOL capacity
• N/A: Displayed if the capacity of the P-VOL or SVOL or the capacities
of both the P-VOL and S-VOL cannot be obtained
• (blank): Indicates that the capacity of the P-VOL and S-VOL are the same
You can use the LOCATE and SORT commands. For details about how to use each command, see
“Command line commands” (page 11).
NOTE:
• Even if you dissolve all of the copy pairs in a copy group, the copy group itself is not deleted.
To delete the copy group itself, the corresponding copy group ID must be deleted from the
Copy Group Selection List panel. If there is a copy group with no copy pairs, the copy group
operation results in an error.
• When you enter an action in the AC column, complete the action by pressing the Enter key,
and then perform the next operation.
• When an EXCTG attribute is defined, if you edit the copy pair definition in this panel, the
storage system information belonging to the copy group might change. Therefore, check the
definition of the EXCTG attribute in the Copy Group Detail Definition panel.
• If the copy group is not a CG container, selecting Use Container and pressing the Enter key
returns the screen to the Copy Group Detail Definition panel. By doing this, you can change
the definition of the copy group from not being a CG container to being a CG container.
84 ISPF panels