HP XP7 Business Continuity Manager Reference Guide (TK954-96004)

Table 71 Contents of the CAA Copy Group Performance Statistics panel (continued)
DescriptionItem
Primary DAD ID in the copy group definition filePrimary Device Addr. Domain
Secondary DAD ID in the copy group definition fileSecondary Device Addr. Domain
Consistency group ID in the copy group definition fileC/T ID
Storage system serial number of the copy sourcePri-SN
Storage system serial number of the copy targetSec-SN
Sidefile threshold of Pri-SNSFTPri %s
Reserved sidefile cache-usage rate for Pri-SNRSF Tot
Reserved sidefile cache-usage rate for C/T for Pri-SNRSF C/T
Write pending rate of Pri-SNWPR Tot
Reserved sidefile cache-usage rate for Sec-SNRSF TotSec %s
Reserved sidefile cache-usage rate for C/T for Sec-SNRSF C/T
Write pending rate for Sec-SNWPR Tot
Data transfer rate between Pri-SN and Sec-SN (KB/s)TRANS Kbytes/s
Off-loading timerOFLD minTIMERS
RCU ready timerRCUR min
Copy pending timerCPND min
NOTE:
• Before displaying CAA performance information in this panel, Usage Monitor should have
started from Remote Web Console. If the copy group consists of XP24000 volumes only, there
is no need to start Usage Monitor.
• For Pri-SN and Sec-SN, information acquired from the storage system is displayed. If the copy
direction is opposite from the direction specified in the copy group definition file, the secondary
and primary storage system serial numbers in the copy group definition file are shown in order
for Pri-SN and Sec-SN.
• The columns where information is not acquired by the storage system and the columns for
copy groups that contain a copy pair whose copy type is not CAA might display N/A because
the values for those columns are not guaranteed.
• When you display the CAJ data transfer rate in this panel, it is necessary that the Usage
Monitor for the control unit (to which the journal volume used by the copy group definition
file belongs) has been started from Remote Web Console, and that the data capture interval
of this Usage Monitor is ten minutes or less.
• If information cannot be acquired from the Sec-Array, the RSF Tot, RSF C/T, and WPR Tot
columns in Sec %s display N/A.
• If information cannot be acquired from the Pri-Array, the SFT, RSF Tot, RSF C/T, WPR Tot and
TRANS Kbytes/s columns in Pri %s, and OFLD min and RCUR min columns in TIMERS display
N/A.
• If an operation is performed on each copy pair or the copy pair directions in the copy group
are mixed, the value for the copy group cannot be guaranteed because the copy pair direction
statuses in the copy group do not match. Match the copy pair statuses and copy pair directions
in the copy group and then re-execute.
Manage Copy Groups Panel (Copy Group Operation) 119