HP XP7 Business Continuity Manager Installation Guide (TK954-96002)

Table 37 If the settings are made by using the YKSETENV command of a version of Business
Continuity Manager 7.6 or later (continued)
Version of Business Continuity Manager being runValue set by using
&YKSYSLG
Value set by using the
YKSETENV command
7.6 or laterFrom 5.1 to 7.5Earlier than 5.1
Output to SYSLOGOutput to SYSLOGOutput to SYSLOGYES'SYSLOG='
No specification
Output to the consoleCONSOLE
Not outputNot outputNO
Output to SYSLOGOutput to SYSLOGNo specification or
specification error
Table 38 If the settings are made by using the YKSETENV command of a version of Business
Continuity Manager from 5.1 to 7.5
Version of Business Continuity Manager being runValue set by using
&YKSYSLG
Value set by using the
YKSETENV command
7.6 or laterFrom 5.1 to 7.5Earlier than 5.1
Output to SYSLOG
#
Output to SYSLOGYESSYSLOG=YES
CONSOLE
NO
No specification or
specification error
Not outputYESSYSLOG=NO
CONSOLE
NO
No specification or
specification error
Output to SYSLOGOutput to SYSLOGOutput to SYSLOGYES'SYSLOG='
No specification
Output to the consoleCONSOLE
Not outputNot outputNO
Output to SYSLOGOutput to SYSLOGNo specification or
specification error
#
This is output to the console if the following condition is met: SYSLOG=CONSOLE was first set
by using the YKSETENV command of version 7.6 or later of Business Continuity Manager, and
SYSLOG=YES was then set by using the YKSETENV command of version 5.1 to 7.5 of Business
Continuity Manager.
Table 39 If the settings are made by using the YKSETENV command of a version of Business
Continuity Manager earlier than 5.1
Version of Business Continuity Manager being runValue set by using
&YKSYSLG
Value set by using the
YKSETENV command
7.6 or laterFrom 5.1 to 7.5Earlier than 5.1
Output to SYSLOG
#1
Output to SYSLOGOutput to SYSLOGYESSYSLOG=YES
No specification
Output to the
console
#2
CONSOLE
Not output
#1#2
Not output
#3
NO
106 Notes when multiple versions of Business Continuity Manager exist