Hitachi Dynamic Link Manager Software Users Guide for Solaris

Value Corresponding facility value in the /etc/syslog.conf file
local7 or 23
local7
This example shows how to specify the audit log facility:
# /opt/DynamicLinkManager/bin/dlnkmgr set -audfac local0
Checking the Updated Settings
This chapter describes how to check the updated settings by using the
dlnkmgr command's set operation after settings have been changed.
When you change some settings, you can display information about all of
HDLM function settings. The following shows an example of the command
used to display the settings information and its execution results:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 2
Elog File Size(KB) : 1000
Number Of Elog Files : 5
Trace Level : 1
Trace File Size(KB) : 2000
Number Of Trace Files : 10
Path Health Checking : on(10)
Auto Failback : on(10)
Intermittent Error Monitor : on(2/20)
Dynamic I/O Path Control : off(10)
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
#
After you have set up the collection of audit log data, use the following
command to make sure that the setting has been specified correctly:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log : on(6)
Audit Log Category : all
Audit Log Facility : local0
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
#
Setting up Integrated Traces
When HDLM is used, the dlnkmgr command logs are output to the integrated
trace information files of Hitachi Network Objectplaza Trace Library
Creating an HDLM Environment
3-149
Hitachi Dynamic Link Manager (for Solaris) User Guide