HP XP7 Command View Advanced Edition Mainframe Agent Installation and Configuration Guide (TK981-96005, May 2014)

MODIFY YK,DISPLAY LOGLEVEL

YKY114I LOGLEVEL=2

Changing the log output level

To change the XP7 mainframe agent log output level, use the MODIFY command with the SETINIT

LOGLEVEL parameter.

Format

If both the name of the cataloged procedure for startup and the identification name were specified

in the START command:

MODIFY

[cataloged-procedure-for-startup-name.]identification-name

,SETINIT LOGLEVEL(output-level)

If only the name of the cataloged procedure for startup was specified in the START command:

MODIFY

cataloged-procedure-for-startup-name

,SETINIT LOGLEVEL(output-level)

Operands

cataloged-procedure-for-startup-name

Used to specify the name of the cataloged procedure for startup that was specified in the START

command when an XP7 mainframe agent was started.

identification-name

Used to specify the identification name that was specified in the START command when an XP7

mainframe agent was started.

SETINIT LOGLEVEL(output-level) ~ <number> ((0 to 2))

Used to specify the new output level.

For details about the output level, see “Parameters” on page 34.

Example

To change the log output level to 2 for an XP7 mainframe agent that was started and whose

identification name is YK, enter the following command:

MODIFY YK,SETINIT LOGLEVEL(2)

YKY111I LOGLEVEL WAS CHANGED

YKY114I LOGLEVEL=2

Using XP7 mainframe agent72