HP IBRIX X9730 Performance Module Installation Instructions (QZ730-96001, June 2012)

Completing setup and configuration
1. Power on the first X9730 PN that corresponds to
the X9730 CX that was installed. See the
following table for guidance.
X9730 PN #X9730 CX #
1 and 21
3 and 42
5 and 63
7 and 84
9 and 105
11 and 126
13 and 147
15 and 168
2. Log in to the server blade. Once you are logged
in, the installation wizard starts automatically and
guides you through the steps to configure the new
server blade and storage and reconfigure the SAS
switches to support the new X9730 Performance
Module. For more information about the
installation wizard, see “Completing the X9730
Performance Module installation” in the HP IBRIX
X9000 Network Storage System Installation
Guide.
3. Repeat steps 1 and 2 for the second X9730 PN
in the server blade pair.
Related information
For additional information, see the following HP
websites:
• http://www.hp.com/go/x9000
• http://www.hp.com/go/storage
To locate the HP IBRIX X9730 Network Storage System
documents, go to the Manuals page at:
http://www.hp.com/support/manuals
Under storage, select NAS Appliances, and then select
HP X9000 Network Storage Systems under IBRIX
Storage Systems.
HP technical support
For worldwide technical support information, see the
HP support website:
http://www.hp.com/support
Before contacting HP, collect the following information:
• Product model names and numbers
• Technical support registration number (if
applicable)
• Product serial numbers
• Diagnostic detail
• Operating system type and revision level
• Detailed questions
Page 8