HP VMA-series Memory Array Installation and Service Guide

Chapter 4 - Configuring the Array
68 VMA-series Memory Array Installation and Service Guide HP-AM456-9002A Rev 01
Configuring the DNS Search Domain Name
When in automatic DNS mode and you set the DNS search domain name, you
are pre-provisioning the value. It is not used until you change the DNS mode to
manual. You can configure the DNS search domain name at any time.
To specify the search domain name of the Memory Array:
1. Log into the CLI via a serial connection or the Ethernet interface (see
Connecting to the CLI on page 59).
2. Navigate to the Ethernet 0 context level. At the root prompt, type:
3. At the Ethernet 0 context prompt, type:
Where:
In the following example, the DNS name server IP address and the DNS search
domain values have been pre-provisioned.
Displaying the DNS Mode and Pre-
provisioned Information
To display the current DNS mode and various pre-provisioned DNS information
on the Memory Array:
1. Log into the CLI via a serial connection or the Ethernet interface (see
Connecting to the CLI on page 59).
2. Navigate to the Ethernet 0 context level. At the root prompt, type:
context chassis controller ethernet 0
set dns-search <value>
value Specifies the search domain name.
chassis controller ethernet 0> show
dhcp enabled
ip-address 10.10.0.126
netmask 255.255.255.0
gateway 10.10.0.1
mac-address 00:1B:97:00:00:06
dns-config automatic
dns-nameserver 10.10.0.2
dns-search violintech.net
prov-dns-nameserver 10.10.0.55
prov-dns-search hi-octane-prod.net
context chassis controller ethernet 0