HP VMA-series Memory Array Installation and Service Guide
Appendix D - CLI Reference
294
VMA-series Memory Array Installation and Service Guide
HP-AM456-9002A Rev 01
Sw-upgrade Context Commands
Figure D.24 System>Sw-upgrade Level
The table below describes the commands available at the Sw-upgrade context
level of the CLI. Access the sw-upgrade context level through the System context
level. See System Context Commands on page 257.
copy system sw-upgrade
Updates the system software factory image if you have both factory and upgrade
images installed on the Memory Array and you want to make the current
upgrade image the factory image.
Syntax
copy system sw-upgrade
Table D.27 Sw-upgrade Context Commands
Command Description
copy system sw-
upgrade
Updates the system software factory image if
you have both factory and upgrade images
installed on the Memory Array and you want to
make the current upgrade image the factory
image.
set active Sets the active partition.
set path Sets the path to specify where the software
upgrade files are located.
show active Displays which partition will boot on the next
system reboot.
show path Displays the path to specify where the software
upgrade files are located.