SAN Solution Installation Guide

Installation
Fibre Channel Bridges
Chapter 2 2-31
If you connect the bridge to your Intranet via the RJ-45 connector, you
can configure and manage the device using Telnet, SNMP, or the built-in
Web interface. FTP and TFTP are supported for firmware upgrades. In
addition to these options, you can make a direct serial connection (RS-
232) to the bridge as well.
Use the supplied cable and the following serial port connection settings
to initiate a connection between your host (running terminal emulation
software) and the bridge.
1. Connect to the bridge while it is powered-off.
2. Power-on and wait until the self-tests and firmware initialization
process completes (may take up to 90 seconds).
3. Press
[ENTER] slowly, seven or eight times and the bridge will
automatically detect the baud rate and connect.
NOTE For additional information see the HP SureStore E Bridge FC 4/1 HV
Installation and Operations Guide, Part Number A4688-90000.
• 8 data bits
• No parity
• One stop bit
• Flow Control: None or XON/XOFF
• Autobaud (9600, 19200, 38400, 57600, or 115200)