HP StoreOnce B6200 Maintenance and Service Guide (February, 2014)

13. Run the auto installation script to add a node to the cluster:
a. After reboot, the installation script will be displayed:
b. Select 2) Join existing cluster.
IMPORTANT: This is an additional node, which must be joined to an existing cluster.
(Do not create a new cluster.)
c. Once the auto-installation script completes, the login prompt appears.
14. Repeat steps 11, 12 and 13 until all the nodes in the cluster are re-imaged, working from
bottom to the top.
15. Connect a monitor and keyboard directly to the VGA output and USB port of the bottom node
in the first rack.
16. Log into the StoreOnce CLI.
• Account: Admin
• Password: admin
17. Enter the following StoreOnce CLI command at the CLI prompt to discover storage:
hardware discover storage
18. Enter the following StoreOnce CLI command to determine storage discovery status:
system show status
This command can be entered at any time to determine storage status.
19. Verify that all the system storage has been discovered
a. Use the system show status command to list the state of the storage for each of the
couplets (two service set pairs).
b. Storage is available as pairs of enclosures. One enclosure will be assigned to the first
node (service set) in the couplet; the other enclosure will be assigned to second node
(service set) in the couplet.
c. Enclosures are populated with either 1 TB or 2 TB hard drives.
d. The storage is configured as RAID6
e. An enclosure pair with 2TB drives will have 48 TB of raw storage and 32 TB of raid
storage.
62 Using the QR ISO image