HP StoreOnce B6200 Maintenance and Service Guide (February, 2014)

7. You now need to configure the trunking. The command sequence varies according to the
number of racks and the location of the switch for which the trunking is being configured.
• Single rack with one or two couplets:
Enter the command trunk ethernet 17-24 trk1 trunk followed by show run to display the
required configuration.
• Two racks
You must configure the trunking for both the first rack and the second rack and you must
configure both switches in each rack.
◦ Rack 1 of a two-rack configuration
Enter the following commands followed by show run to display the required
configuration.
For “R1 Sw A” (10.154.6.1):
For “R1 Sw B” (10.164.6.2):
This will return a display similar to the following:
Network switch firmware (whole unit replacements) 39