HP StoreOnce 2700, 4500, 4700 and 4900 Backup System User Guide

1. Use the following StoreOnce CLI to remove all configured storage on the appliance (except
that used by the operating system):
hardware delete storage all
2. This will clean up all filesystem configuration and delete LUNs on all storage devices.
WARNING! This command will completely remove all configured storage, and will run at
any time even if the storage is healthy.
3. After the delete command has completed rebuilding the storage system, use the following
StoreOnce CLI commands to discover and add storage to the system.
hardware discover storage
hardware add storage
This configures both the storage in the appliance (base storage) and any attached expansion
shelves, if licenses are present on the appliance.
If complete data loss occurs 177