HP StoreOnce Backup System CLI Reference Guide

time del ntpserver
Description of Command Function
Removes an ntp server which exists for the HP StoreOnce appliance.
Command Syntax
time del ntpserver {<FQDN>|<IPv4>}
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
• ntp server ID – At least one ntp server ID must appear in the command entry. This parameter
appears after time del ntpserver and consists of either a fully-qualified name (FQDN)
or an IPv4 address in the xx.xx.xx.xx format. Depending on the number of ntp server objects
which currently exist for the StoreOnce appliance, up to two ntp server ID parameters may
exist within the command entry. (No more than two ntp server objects can exist for a given
StoreOnce appliance.)
• ntpX – A string matching the label of an existing ntp server object.
Requirements for Command Execution
• The command entry must conform to command syntax.
• The NTP server object defined within the command entry must exist.
• If NTP is enabled, execution of the command cannot remove all the timeserver objects.
Successful Command Output
Upon successful completion of the command, the following is displayed:
NTP deleted, where NTP is the time server object defined in the command entry.
Command Operation during Abnormal Conditions
• If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
• If the ntp server object defined in the command entry does not exist, the following is displayed:
Command Failed - NTP does not exist, where NTP is the time server object defined
in the command entry.
Example
time del ntpserver 16.110.124.123 - Deletes the ntp server
time del ntpserver fe80::0202:b3ff:fe1e:8329 - Deletes the ntp server
208 Alphabetical List of Commands and Details