HP Store Once Backup System 2700, 4500 and 4700 Installation and Configuration Guide

2. Slide the HP StoreOnce Backup system into position in the rack and secure it to the rack rails
using thumbscrews on the unit's front bezel.
IMPORTANT: The label on the top of the HP StoreOnce Backup system contains useful identity
information, such as the MAC address and default network name. It also contains the iLO
password for the system. Make a note of this information before you install the HP StoreOnce
Backup system in the rack. See Password best practices (page 31) for more information about
passwords and best practices after initial configuration.
The following figure illustrates how to mount the HP StoreOnce Backup system, using the HP
StoreOnce 2700 model as an example.
Figure 1 Secure the HP StoreOnce Backup system to the rack
NOTE: The HP StoreOnce 2700 Backup system is supplied with a single power supply. If
you have purchased the optional second power supply, be sure to install it before continuing
with the installation.
Attaching SFPs, StoreOnce 4500 and 4700 only
The Accessory Kit supplied with the HP StoreOnce 4500 and 4700 Backup system contains the
appropriate number of 8Gb Short Wave FC SFP+ and 10Gb SR SFP+.
Unpack these and connect them to the corresponding ports on the rear of your product as shown
below.
Attaching SFPs, StoreOnce 4500 and 4700 only 19