Web Tools Administrator's Guide (53-1001772-01, June 2010)

Web Tools Administrator’s Guide 175

53-1001772-01

Fabric Watch threshold configuration

DRAFT: BROCADE CONFIDENTIAL

• State change

• Trunk utilization

• C3 discards

• RX performance

• TX performance

• Loss of signal

• Link failures

• Link resets

• Packet loss

• Utilization

Use the following procedure to configure threshold alarms.

1. Open the Fabric Watch window.

2. Select the Threshold Configuration tab.

3. Select the Alarm Configuration subtab.

4. In Fabric Watch Explorer, select a class.

5. Under Area Selection, select an area from the drop-down list.

NOTE

The module displays two tables of alarm configuration information, labeled System Default

and Custom Defined. You cannot modify the information in the System Default table.

6. In the Activate Level area:

• Click System Default o use the system default settings and proceed to step 8.

• Click Custom Defined to specify new settings and proceed to the next step.

7. Select the check box for the type of notification method you want to use for each event type

(Changed, Below, Above, Inbetween).

The available alarm actions are:

• ERROR_LOG

• SNMP_TRAP

• RAPI_TRAP

• PORT_LOG_LOCK

• EMAIL_ALERT

8. Click Apply.