HP B-series Fabric OS 7.1.0c Release Notes (5697-2892, October 2013 - includes all 7.1.0x versions)

Table 9 Fabric OS 7.1.0 closed defects (continued)
SolutionClosed defect summary
Workaround prior to upgrade:Rolling reboots occur when a faulty HP DC SAN Director
Multiprotocol Extension Blade is detected.
Relocating the HP DC SAN Director Multiprotocol Extension
Blade to a different slot may alleviate the underlying
hardware fault.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.The cfgsave command may intermittently fail following
multiple zoneobjectrename commands.
Fixed in Fabric OS 7.1.0.FICON emulation errors may occur.
Fixed in Fabric OS 7.1.0.WebTools intermittently returns the error "The switch is
currently not accessible. Your request has failed due to
network IP connection loss or the switch is not running at
this moment" when attempting to perform "Beacon" and
"Chassis Beacon" functions.
Fixed in Fabric OS 7.1.0.FCIP VE Port invalid FC Receives are not counted in a
statistic.
Fixed in Fabric OS 7.1.0.FICON Tape Write Pipelining failures occur when writing
large blocks to a 3rd party device (a virtual tape controller).
Missing Device end errors are displayed during tape write
pipelining.
Workaround prior to upgrade:VM host not able to vary on Tape CHPIDs through the
FICON Tape Emulating Tunnel.
Disable FICON Tape Pipelining, or upgrade Fabric OS
and modify the FCIP Tunnel FICON Debug flags to include
the 0x20 bit. The command to modify the FICON Debug
Flag value is: portcfg fciptunnel <slot/>vePort
modify --ficon-debug <flag>
Where "flag" is a hex number that includes the 0x20 bit.
e.g. root> portcfg fciptunnel 16 modify
--ficon-debug f7c90020
You can confirm the FICON Debug Flag setting by the
following command:
Spike163:root> portshow xtun 16 -ficon
-stats
Output at the end of the display will include the current
FICON debug flag settings:
Bit 5 [0x00000020] = 1 :
DISABLE_TAPE_MULTIPATH_PROTECTION
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.While enabling FICON FMS mode on the default switch,
it fails with following raslog: [FICU-1001], , , ERROR, ,
(Mode cannot be enabled since address mode is 8 bit
Dynamic Area Mode).
Fixed in Fabric OS 7.1.0.On a busy switch, Fabric Watch falsely reports "build
fabric" event.
Fixed in Fabric OS 7.1.0.The swEventTimeInfo, swFwName and swFwLabel MIBS
do not match the MIB reference manual and display
incorrectly.
Fixed in Fabric OS 7.1.0.Brocade 10 Gb/s FC ports are unable to interoperate with
a third-party 10 Gb/s FC ports on DWDM equipment.
Fixed in Fabric OS 7.1.0.After an HA Failover, multiple online switch ports become
persistently disabled when a Logical Switch is created after
an upgrade to Fabric OS 7.0.x in a FICON setup.
60