Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

Web Tools Administrator’s Guide 69
53-1001194-01
Restoring a configuration
4
An info link is enabled when USB is chosen as the source of the configuration file. If you click
on info
, the following information message is displayed.
6. Type the configuration file with a fully-qualified path, or select the configuration file name in
the Configuration File Name field.
7. Use the Fabric ID selector to select the fabric ID of the logical switch from which the
configuration file is to uploaded. The selector will show all the virtual fabric IDs that have been
defined, the default of 128 for the physical switch, chassis level configuration, and all chassis
and switches.
NOTE
If you are using a USB device, it must be connected and mounted before you upload or download.
Refer to “Uploading and downloading from USB storage” for more information.
8. Click Apply.
You can monitor the progress by watching the Upload/Download Progress bar.
Restoring a configuration
Restoring a configuration involves overwriting the configuration on the switch by downloading a
previously saved backup configuration file. Perform this procedure during a planned down time.
Make sure that the configuration file you are downloading is compatible with your switch model.
Configuration files from other model switches might cause your switch to fail.
1. Open the Switch Administration window.
2. Select Show Advanced Mode.
3. Select the Configure tab.
The Configure screen is displayed.
4. Select the Upload/Download tab.
The Upload/Download configuration screen is displayed ().
By default, Config Upload is chose under Function, and Network is chosen as the source of the
configuration file.