Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

Web Tools Administrator’s Guide 85
53-1001194-01
Configuring FC ports
5
The following procedure describes how to open the FC Port Configuration wizard. The wizard is self-
explanatory, so the explicit steps are not documented here.
1. Click a port in the Switch View to open the Port Administration window (see Figure 41 on
page 80).
2. Click the FC Ports tab.
FIGURE 45 FC Port Configuration Wizard, FC Ports
3. Select the port you want to configure from the tree on the left.
4. Click the General subtab.
Long distance does not display from the General or Table subtabs if the EGM license is not
enabled on the switch.
5. Click Edit Configuration.
The FC Port Configuration wizard opens. The fields are populated with the current
configuration values.
Long distance is not displayed from the Edit Configuration window as shown is Figure 45. You
can view long distance from the View tab when you display port details.
6. Follow the steps in the wizard.
If you configure a disabled port as an EX_Port, the wizard displays the Enable Port after
configuration check box. If you select the check box, the disabled port is automatically enabled
after configuration; otherwise, the port remains in the same state after configuration.