Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

586 Fabric OS Command Reference

53-1001186-01

portCfgTrunkPort

Enables or disables trunking on a port.

Synopsis portcfgtrunkport [slot/]port[,] mode

Description Use this command to enable or disable trunking on a port. Use switchCfgTrunk to enable or disable

trunking on all ports of a switch.

When the command is executed to update the trunking configuration, the port to which the

configuration applies is disabled and subsequently re-enabled with the new trunking configuration.

Traffic through the ports may be temporarily disrupted.

Disabling trunking fails if a Trunk Area (TA) is enabled on the port. Use the portTrunkArea command

to remove the TA before disabling trunking.

Notes Enabling trunking requires an ISL Trunking license. You may disable trunking without a license.

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details.

Operands This command has the following operands:

slot For bladed systems only, specifies the slot number of the port to be

configured, followed by a slash (/).

port Specifies the port to be configured, relative to its slot for bladed systems. Use

switchShow to display a listing of valid ports.

mode Specify 1 to enable trunking on the specified port. Specify 0 to disable

trunking on the port. This operand is required. Trunking is enabled by default,

when a trunking license is present on the switch.

Examples To enable a port for trunking:

switch:admin> portcfgtrunkport 1/3, 1

See Also portCfgShow, portShow, switchCfgTrunk, portTrunkArea, switchShow